Fujitsu Stylistic ST6010 User Manual page 77

To obtain additional screen protectors, use Fujitsu part number FPCSP08AP (6-pack) when ordering.
Additional information about installation is included with the screen protectors.
D
URING NORMAL USE OF THE
EMBEDDED IN THE PEN TIP AND SCRATCH THE SCREEN
ENSURE THAT A SCREEN PROTECTOR IS INSTALLED BEFORE USING YOUR
WARRANTY DOES NOT COVER A SCRATCHED SCREEN
To install a new screen protector on your Tablet PC:
1
If a screen protector is already installed on the display screen, remove it before installing the new screen
protector. The screen protector is held onto the display screen surface by a thin strip of adhesive around the
edges.
2
Clean the display by wiping the screen gently using a soft cotton cloth dampened with isopropyl alcohol. Ensure
that all residue has been removed from the screen before applying a new screen protector. Remove the
protective coating from the adhesive side of the screen protector first.
•
T
HE
OR WASH IT WITH A HEAVILY SOAKED CLOTH
•
D
O NOT PLACE ITEMS ON THE TOP OF THE DISPLAY
3
Apply the screen protector to the display screen surface. When doing so, orient the screen protector with the
adhesive side of the screen protector facing the display screen as shown in Figure 19.
4
Apply pressure to the screen protector with your finger using a continuous wiping motion along the edges. The
adhesive sets completely within 48 hours. To ensure a good seal between the screen protector and the display,
do not lift the screen protector from the display once it has been applied.
5
Remove the protective plastic cover from the face of the screen protector, as shown in Figure 20.
/
T
ABLET
S ST6000 S T
TYLISTIC ERIES ABLET
76 - Caring for your Tablet PC
PC,
SMALL PARTICLES FROM THE ENVIRONMENT CAN BECOME
. T
O PREVENT SCRATCHING THE SCREEN
.
PC . D
IS NOT WATERPROOF
.
,
OR DAMAGE MAY OCCUR
T PC. T
ABLET HE
O NOT POUR LIQUIDS ON THE SYSTEM
.
,