Powering On/Off; Connecting The Power Cord; Power Indicator - Panasonic PT-TX340 Operating Instructions Manual

Powering on/off

Connecting the power cord

Make sure that the supplied power cord is securely fixed to the <AC IN> terminal of the projector body to prevent it from being
removed easily.
For details of power cord handling, refer to "Read this first!" (x page 4).
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the connector completely in the correct direction.
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal.

Power indicator

The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Confirm the status of the power indicator
<ON(G)/STANDBY(R)> before operating the projector.
Power indicator <ON(G)/STANDBY(R)>
Indicator status
No illumination
Lighting
Red
Blinking
Lighting
Green
Blinking
Lighting
Orange
Blinking
34 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
The power plug is not connected to the outlet.
The projector is turned off. (In standby mode)
The projector is preparing to project.
The projector will project image after a while.
The projector is preparing to be switched off.
The power is switched off after a while. (Changes to the standby mode.)
Projecting.
The luminous lamp is turned off. The [Expand] menu → [Power management] is set to [Ready].
Internal malfunction is detected. For details, refer to "Power/Warning Indicators". (x page 91)
x
Status