Saeco PicoBaristo HD8927/06 Manual page 40

English
40
The brew group cannot be
removed.
The brew group cannot be
inserted.
The coffee has too little
cream or is watery.
The coffee is not hot
enough.
The coffee grounds container was
placed back too fast.
The brew group is not positioned
correctly.
The coffee grounds container is not
removed.
The machine is still in the descaling
process.
The brew group is not in the correct
position.
The grinder is set to a coarse setting.
The brew group is dirty.
The coffee exit duct is dirty.
The coffee blend is not the correct
one.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
Do not place back the coffee
grounds container until the screen
message prompts you to put it
back.
Close the service door. Switch the
machine off and back on again.
Wait for the machine ready screen
to appear and then remove the
brew group.
Remove the coffee grounds
container before removing the
brew group.
You cannot remove the brew
group when the descaling process
is active. First complete the
descaling process and then
remove the brew group.
The brew group was not put in rest
position before it was placed back.
Make sure that the lever is in
contact with the base of the brew
group and that the hook of the
brew group is in the correct
position.
Reset the machine by switching it
on and off. Place the drip tray and
the coffee grounds container back.
Leave the brew group out. Close
the service door and switch the
machine on and off. Then try to
reinsert the brew group.
Adjust the grinder to a finer setting.
Clean the brew group. For
thorough cleaning, follow the
monthly cleaning procedure with
the degreasing tablet.
Clean the coffee exit duct
thoroughly with the handle of the
multifunctional tool or a spoon
handle.
Try another coffee blend.
Preheat the cups by rinsing them
with hot water.
Set the temperature to high in the
menu.
Whether the milk you add is warm
or cold, it will always decrease the
temperature of the coffee to some
extent.