Table of Contents
Advertisement
4.7 Maintenance and cleaning
Service life of product extends and frequently experienced problems will be reduced if it is
cleaned at regular intervals.
4.7.1 Cleaning the detergent drawer
1
Press the dotted point on the siphon in the softener compartment and pull towards
you until the compartment is removed from the machine.
2
Lift the rear part of the siphon to remove it as illustrated.
3
Wash the detergent drawer and the siphon with plenty of lukewarm water in a
washbasin. In order to prevent the residues to contact your skin, clean it with an
appropriate brush by wearing a pair of gloves.
3
Insert the drawer back into its place after cleaning and make sure that it is seated
well.
4.7.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please see Operating the product -
Programmes.
C
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing machines.
4.7.3 Cleaning the body and control panel
Wipe the body of the product with soapy water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
34 / EN
Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to prevent
accumulation of powder detergent in time.
If more than normal amount of water and softener mixture
starts to gather in the softener compartment, the siphon
must be cleaned.
After every washing make sure that no foreign substance is
left in the drum.
If the holes on the bellow shown in the figure are blocked,
open the holes using a toothpick.
Foreign metal substances will cause rust stains in the drum.
Clean the stains on the drum surface by using cleaning
agents for stainless steel.
Never use steel wool or wire wool. These will damage the
painted, chromated and plastic surfaces.
Washing Machine / User's Manual
Advertisement
Table of Contents
