Table of Contents
Advertisement
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN 1/2)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan
of maximum 1A (12 W) fan power.
ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
•
•
M.2 socket 3
These sockets allow you to install an M.2 (NGFF) SSD
module.
These M.2 sockets support M Key and 2242/2260/2280
storage devices.
Intel
LGA1151 CPU socket
®
Install Intel
designed for 8th Generation Intel
processors.
For more details, refer to Central Processing Unit (CPU).
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
For more details, refer to System memory.
Intel
B365 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~6 )
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
1-2
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides
a minimum power of 350 W.
We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
Core™ i7 / i5 / i3, Pentium
®
Chapter 1: Product introduction
M.2(SOCKET3)
, and Celeron
®
®
Advertisement
Table of Contents
