Function List; Servo Setup; Travel Adjust; Sub-Trim - Spektrum SPMR8105 Instruction Manual

Table of Contents

Advertisement

FUNCTION LIST

The Main Screen appears when you power on the transmitter. Press the scroll wheel once to display the Function List.

Servo Setup

The Servo Setup menu contains the following functions:

• Travel Adjust

• Sub-Trim

4 Travel Adjust
Travel Adjust sets the overall travel or endpoints of the servo arm
movement.
To adjust travel values:
1. Scroll to the channel you wish to adjust and press the scroll
wheel. When adjusting travel values assigned to a control stick:
a. Center the control stick to adjust both directions at the
same time.
b. To adjust travel in one direction only, move the control
stick in the direction you wish to adjust. Continue hold-
ing the control stick in the desired direction while you
are adjusting the travel value.
2. Scroll left or right to adjust the travel value. Press the scroll
wheel to save the selection.
IMPORTANT: ALT, ROL, PIT and YAW replaces THR, AIL, ELE and
RUD channels in multirotor to more closely refl ect the fl ight axis
in the multirotor aircraft. This change is throughout the multirotor
menu options.
4 Sub-Trim
Sub-Trim adjusts the servo travel center point.
NOTICE: Use only small sub-trim values or you may cause
damage to the servo.

4 Reverse

Use the Reverse menu to reverse the channel direction. For
example, if the elevator servo moves up and it should move down.
To reverse a channel direction:
1. Scroll to Travel and press the scroll wheel. Scroll left until
Reverse appears and press the scroll wheel again to save the
selection.
2. Scroll to the channel you wish to reverse and press the scroll
wheel.
If you reverse the Throttle channel, a confi rmation screen
appears. Select YES to reverse the channel. A second screen
appears, reminding you to bind your transmitter and receiver.
SPEKTRUM DX8e • TRANSMITTER INSTRUCTION MANUAL
• Reverse
• Speed
CAUTION: Always rebind the transmitter and receiver after
reversing the Throttle channel. Failure to do so will result
in the throttle moving to full throttle if failsafe activates.
Always perform a control test after making adjustments to confi rm
the model responds properly.
CAUTION: After adjusting servos, always rebind the
transmitter and receiver to set the failsafe position.
EN
• Balance
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dx8eSpmr8105eu

Table of Contents