Table of Contents
Advertisement
3.
Remove the rod and the bearing.
1
2
► 1 . Rod 2. Bearing
NOTE: The rod or bearing may remain on the cover.
4.
Remove 2 bolts, 2 sleeves, and the felt pad, and
then remove the shear blades.
1
2
3
► 1 . Felt pad 2. Bolt 3. Sleeve 4. Shear blades
NOTICE:
Be careful not to lose the bolts.
5.
Remove the blade cover, and then attach it to the
new shear blades.
6.
the alignment line.
► 1 . Hole 2. Alignment line
7.
at the same position.
4
► 1 . Protrusion
8.
► 1 . Felt pad
13 ENGLISH
Adjust the crank so that 2 holes are lined up on
2
Align the protrusions on the shear blades vertically
Attach the felt pad to the shear blades.
1
1
1
1
Advertisement
Table of Contents
