Makita GA023G Instruction Manual page 12

Installing or removing wheel guard
WARNING:
When using a depressed center
wheel, flap disc, flex wheel or wire wheel brush,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
WARNING:
Make sure that the wheel guard is
securely locked by the lock lever with one of the
holes on the wheel guard.
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
(In some European countries, when using a diamond
wheel, the ordinary guard can be used. Follow the
regulations in your country.)
For depressed center wheel, flap disc,
flex wheel, wire wheel brush / abrasive
cut-off wheel, diamond wheel
1.
While pushing the lock lever, mount the wheel
guard with the protrusions on the wheel guard aligned
with the notches on the bearing box.
1
► 1. Lock lever 2. Notch 3. Protrusion
2.
guard by holding down the portions B as shown in the figure.
► 1. Wheel guard 2. Hole
NOTE: Push down the wheel guard straight. Otherwise,
you cannot push the wheel guard completely.
3.
described in step 2, rotate the wheel guard toward C, and then,
3
change the angle of the wheel guard according to the work.
2
► 1. Wheel guard 2. Hole
12 ENGLISH
While pushing the lock lever toward A, push in the wheel
B
While keeping the lock lever and wheel guard position as
C
B
B
B
A
1
2
B
A
C
1
2