4.
Press the button and choose the desired number.
The displayed number changes fast by keeping
pressing the button. To set the first digit, pull the
switch trigger and then release it.
5.
The lamp on the right side of the display starts to
blink so that the number of second digit can be
changed.
6.
Press the button and choose the desired number.
The displayed number changes fast by keeping
pressing the button. To set the second digit, pull
the switch trigger and then release it.
7.
For the final setting, pull the switch trigger while
pressing the indication button. The number of
impacts is set at once.
To reconfigure the number of impacts, pull the
trigger without pressing the indication button so
that return to 3 above.
Confirming the current setting number
To check the current setting number, pull the trigger
once, release it and then press the indication button.
Relation between presetting number and
action
Presetting
Clockwise rotation
number
0
Auto-stop setting does not work.
01 - 99
After impacting [number of
impacts (presetting number
x 2) x 0.02] seconds.
Green color lamp lights on.
Switch off before impacting
[number of impacts
(presetting number x 2)
x 0.02] seconds.
Red color lamp lights on.
Then, the lamp goes out.
003611
NOTE:
Use presetting number as a guideline. To keep the
•
fastening torque, number of impacts changes
automatically by remaining battery capacity.
Indicating lamp
013665
After impacting preset numbers, the indicating
•
lamp lights in green color.
Counterclockwise rotation
Auto-stop setting does not work.
Auto-stop setting does not work.
Indication lamp goes out.
1. Indicating lamp
1
The red color light will light on if the trigger is
•
released before the presetting number of impacts
is achieved. It indicates that the operation is
incomplete.
When auto-stop mechanism is working, the
•
indicating lamp lights red while the switch trigger is
being pulled.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
For tool with shallow bit hole
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
8