Larson Electronics WAL-QP-4X500-25 Instruction Manual

Portable Work Area Flood Lights on Quadpod Mount
The WAL-QP-4X500-25 Quadpod Mounted Work Area Light produces 35,000 lumens of light capable of
illuminating an area 11,500 square feet in size. This adjustable light tower is designed for portability and
durable operation and ideal for use in demanding industrial and outdoor construction conditions.
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK
•
Do not use with extension cord near water or
where water may accumulate.
•
Keep plugs and receptacles dry.
•
For use only on GFCI protected circuits.
•
Risk of burns, do not operate without lens.
•
Lighted lamp is hot. Keep away from
combustibles. Unplug to change bulb. Do not
touch bulb.
WARNING RISK OF FIRE, ELECTRIC SHOCK,
EXPOSURE.

QUADPOD ASSEMBLY

The quadpod assembly consists of 3 parts:
1. Light head
2. Pole w/Legs
3. Wheel base
To assemble quadpod, begin by placing the legs over the wheel base. Tighten bolt to secure the
wheels. The quadpod can now be rolled around on its wheels. Ensure the legs are folded up before
tilting quadpod to maneuver.
WARNING: Use caution before tilting quadpod with a heavy load. For heavy loads, it is
recommended to remove the light head prior to transporting via wheel base! Failure to do so may
cause serious injury or death. Larson Electronics shall not be held liable for injuries caused by
misuse.
1. Place tower in desired location that is flat and able to support the quadpod without falling over.
2. Loosen hand screw and lower legs until firmly stabilizing quadpod.
3. Tighten hand screw to secure legs.
4. With help, place the light head over top pole and tighten hand screw.
Light weight lamps can be attached by tilting quadpod toward the ground with the legs up. Attach light
head to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt quadpod while
extended to max height. It is recommended to have another person hold the quadpod while tilting
vertically.
Larson Electronics, LLC
4x 500w Quartz Lights – 25' Cord
Instruction Manual
Phone: (800) 369-6671
TO EXCESSIVE UV RADIATION OR INJURY TO
PERSONS
•
Unit operates on 120V AC 50/60 Hz only
•
Unplug and allow cooling before replacing bulb.
•
Bulb gets HOT quickly
•
Do not touch hot lens guard or enclosure.
•
Do not remain in light if skin feels warm.
•
Do not look directly at lighted lamp.r
•
Keep lamp away from materials that may bum.
•
Do not touch the bulb at any time; use a soft
cloth or gloves. Oil from skin may damage bulb.
•
Do not operate the lamp with missing or
damaged guard, lamp containment barrier or
UV light filter.
Fax: (903) 498-3364
WAL-QP-4X500-25
www.larsonelectronics.com 1 of 3