Edid Setting - SY Electronics SY-MUHD-44 User Manual

SY-MUHD-44 & SY-MUHD-88

EDID Setting

The matrix switcher has 12 built-in factory defined EDID setting, and three user programmable EDID
memories. The user EDID memories are independent to each input and can therefore be set differently for
each input. The matrix switcher can also be set to use the EDID information from any of the output display
devices.
To change the EDID setting, press and hold any INPUT button for 3 seconds and the LCD display will show
the current EDID setting for that input channel.
The EDID setting will be one of the following:
1：1080P 2CH (PCM)
2：1080P audio 5.1
3：1080P audio 7.1
4：1080P 3D 2CH (PCM)
5：1080P 3D audio 5.1
6：1080P 3D audio 7.1
7：4K30Hz 3D 2CH (PCM)
8：4K30Hz 3D audio 5.1
9：4K30Hz 3D audio 7.1
10：4K60Hz (Y420) 3D 2CH (PCM)
11：4K60Hz (Y420) 3D audio 5.1
12：4K60Hz (Y420) 3D audio 7.1
USER EDID 1
USER EDID 2
USER EDID 3
EDID from output 1
EDID from output 2
EDID from output 3
EDID from output 4
The first twelve EDID settings are factory set and cannot be altered. The three USER EDID memories can only
be programmed using RS232 commands. The EDID from any output can be programmed either using the
front panel controls as described below, or by using RS232 commands. Each input presents its currently
selected EDID setting to the HDMI source device, therefore only one EDID setting is active at any instant for
an input, but this setting can be different for each input.
The following is an example of how to change the EDID setting for input 3:
User Action
Press and hold button 3 for 3 seconds.
Click button 3 to step to the next EDID setting.
(This step can be repeated until the desired EDID setting is
displayed)
www.sy.co.uk
LCD Text after User Action
5