Table of Contents
Advertisement
Installation Guide
p
Trace the dots (
When angle adjustment is performed correctly, the dots you have traced disappear.
c
Touch operations may not perform correctly if you are wearing artificial nails or nail polish, or
if your fingers are obstructed by bandages and so on.
When all of the dots have disappeared, select Complete and press the [
control. Then, go to step 17.
If some dots remain as shown in the following figure, check the following points.
If the dots on the left and right do not disappear: Remove any obstacles that are on the left and right
of the projection screen. After removing any obstacles, press the [
control, and then perform step 16 again. Perform additional adjustment if dots still remain even after
performing this step, or if there are obstacles that cannot be removed such as whiteboard trays or
frames.
"Additional adjustments"
s
) with your finger
p.83
] or [
82
] button on the remote
] button on the remote
Advertisement
Table of Contents
