Table of Contents
Advertisement
r Enter a PIN code
i) Press as to select a number from 0 to 9.
ii) Press the <ENTER> button.
f The fixed number change to , the cursor move to the next digit.
iii) Repeat the above steps, and enter a three-digit number.
f Move the cursor to [Set] after fixing the three-digit number.
iv) Press the <ENTER> button.
f Return to the [Security] screen.
7)
Press as to switch the item.
f The items will switch each time you press the button.
[On]
[Off]
Note
f If you want to correct the digit, press the <MENU> button to reset the digit and then re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
[PIN code change]
Change the PIN code.
1)
Press as to select [Security].
2)
Press the <ENTER> button.
f The [Security] screen is displayed.
3)
Press as to select [PIN code change].
4)
Press the <ENTER> button.
f The [PIN code] input screen is displayed.
5)
Enter the PIN code you have set according to the steps in "Enter a PIN code" (x page 69).
6)
Press the <ENTER> button.
f The [New PIN code] input screen is displayed.
7)
Enter the New PIN code according to the steps in "Enter a PIN code".
[Power management]
Switch the projector to standby state or ready state when the no-signal status continues. You can select the standby state or
ready state, the waiting time it takes for the power management function to work, as well as the waiting time before switching
from the ready state to the standby state.
1)
Press as to select [Power management].
2)
Press the <ENTER> button.
f The [Power management] screen is displayed.
3)
Press as to select [Ready], [Shut down] or [Off].
When there is no signal input for 30 seconds, the countdown timer is displayed. When the time set in
[Timer] has elapsed, the luminous lamp turns off and the projector enters the Ready state after cooling.
If a signal is input in Ready mode, or when you press any button other than the power <v/b> button,
the luminous lamp turns on and the projector enters the projection state. Pressing the power <v/b>
[Ready]
button during the Ready state will enter the standby state.
In addition, when the time set in [Ready countdown] has elapsed,the projector will switch from the
Ready state to the standby state.
When there is no signal input for 30 seconds, the countdown timer is displayed. When the time set
[Shut down]
in [Timer] has elapsed, the luminous lamp turns off and the projector enters the standby state after
cooling.
[Off]
Disables the power management function.
Chapter 4 Settings - [Expand] menu
The [PIN code] screen will be displayed when the projector is turned on. The projector cannot be
operated without entering the PIN code.
The projector can be operated without the PIN code.
ENGLISH - 69
Advertisement
Table of Contents
