Table of Contents
Advertisement
[Setting] menu
On the menu screen, select [Setting] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 47) for the operation of the menu screen.
[On start]
Set the startup method which will be applied when the projector is powered on after connecting the power plug to outlet.
1)
Press as to select [On start].
2)
Press the <ENTER> button.
3)
Press as to switch the item.
f The items will switch each time you press the button.
[Off]
[On]
[Standby mode]
Set the standby power consumption. Change the setting whether or not use the network function.
1)
Press as to select [Standby mode].
2)
Press the <ENTER> button.
3)
Press as to switch the item.
f The items will switch each time you press the button.
[Eco]
[Normal]
*1
*1 For PT-LB305D, network function is unavailable.
Note
f If [Standby mode] is set to [Eco], you cannot use network functions and some RS-232C commands.
[High land]
Change the setting according to the altitude in which you use the projector.
1)
Press as to select [High land].
2)
Press the <ENTER> button.
3)
Press as to switch the item.
f The items will switch each time you press the button.
[Off]
[On 1]
[On 2]
Note
f It is set to [Off] when using the projector in the elevation of below 700 m (2 297'). It is set to [On 1] when using the projector
in the elevation of above 700 m (2 297') and below 1 400 m (4 593'). It is set to [On 2] when using the projector in the
elevation of above 1 400 m (4 593') and below 2 700 m (8 858'). Failure to do so may shorten the life of the internal parts
and result in malfunctions.
f Do not set the projector in the elevation of 2 700 m (8 858') or above, otherwise it may shorten the life of the internal parts
and result in malfunctions.
f When it is set to [On 1] or [On 2], the fan noise becomes louder and fan speed increases.
[Lamp control]
Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1)
Press as to select [Lamp control].
2)
Press the <ENTER> button.
Chapter 4 Settings - [Setting] menu
Starts up in the standby mode.
Starts the projection immediately.
Select this item to reduce power consumption during standby.
Select this item to use the network function or the serial communication function during standby.
When using the projector in the elevation of below 700 m (2 297').
When using the projector in the elevation of above 700 m (2 297') and below 1 400 m (4 593').
When using the projector in the elevation of above 1 400 m (4 593') and below 2 700 m (8 858').
ENGLISH - 57
Advertisement
Table of Contents
