Table of Contents
Advertisement
Faults
Drying time too long?
Condensation in the
exhaust air duct.
Displayed drying time
changes during drying
process.
Humidity in the room
increases.
One or more indicator
lights are flashing.
Power cut.
* depending on the model
If you cannot rectify the fault yourself by turning the dryer off and on, please
Note:
contact our after-sales service.
Cause/remedy
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
■
ter.
Unsuitable programme selected?
■
Dryer installed too closely to other objects? Provide adequate air circulation.
■
If the ambient temperature is higher than 35 °C, this may extend the drying
■
time.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Mains failure? Restart the dryer.
■
Exhaust air duct too long? Check the maximum exhaust air duct lenght. Futher
information ~ Page 14.
Not a fault. The moisture sensors detect the remaining moisture in load and cor-
rect the programme lenght (except timed programmes).
Not a fault. Make sure the room is sufficiently ventilated.
■
Exhaust air duct installed/the exhaust air routes directly into the open air?
■
~ Page 14
Clean the fluff filter ~ Page 30.
■
Check the installation condition ~ Page 13.
■
Exhaust air duct blocked or bent? Clean the exhaust air duct ~ Page 33.
■
Switch off, allow to cool, switch back on, and restart the programme.
■
The drying program is interrupted. Remove the laundry and spread it out, or
restart the program.
Be careful as the door , the drum and the laundry may be hot.
Note:
Faults and what to do about them
en
35
Advertisement
Table of Contents
