Keystone KSTAP12QD Instruction Manual page 9

Installation
Note: Once the Exhaust Hose assembly and Adjustable Window Slider
are prepared, choose from one of the following two installation methods.
Type 1: Hung Window Installation
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Cut the adhesive foam seal A
and B strips to the proper
lengths, and attach them to
the window sash and frame
as shown.
Foam seal C
(Non-adhesive type)
Cut the non-adhesive foam
seal C strip to match the width
of the window. Insert the seal
between the glass and the
window frame to prevent air
and insects from getting into
the room.
Window slider B
Window slider A
(if required)
Insert the window slider
assembly into the window
opening.
Security Bracket
2 Screws
If desired, install the security
bracket with 2 screws as shown.
Insert the window slider adaptor
into the hole of the window slider.
Type 2: Sliding Window Installation
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Cut the adhesive foam seal A
and B strips to the proper
lengths, and attach them to
the window sash and frame
as shown.
8
Window slider B
(if required)
Window slider A
Insert the window slider
assembly into the window
opening.