Troubleshooting - Whirlpool ACP102PR2 Use & Care Manual

Before calling for service, try the suggestions below to see whether you can solve your problem without outside help. If you still
need help, see "Assistance or Service."
Problem Possible Cause
Air conditioner will
not operate
Air conditioner
blows fuses or trips
circuit breakers
Air conditioner
power supply cord
trips (Reset button
pops out)
Air conditioner
seems to run too
much

TROUBLESHOOTING

The power supply cord is
unplugged.
The power supply cord has
tripped (Reset button has
popped out).
A household fuse has
blown, or a circuit breaker
has tripped.
The Power button has not
been pressed.
The local power has failed. Wait for power to be restored.
Too many appliances are
being used on the same
circuit.
Time-delay fuse or circuit
breaker of the wrong
capacity is being used.
An extension cord is being
used.
You are trying to restart the
air conditioner too soon
after turning off air
conditioner.
You have changed modes. Wait at least 3 minutes after turning air conditioner off before trying to restart
Disturbances in your
electrical current can trip
(Reset button will pop out)
the power supply cord.
An electrical overloading,
overheating, pinching or
aging can trip (Reset button
will pop out) the power
supply cord.
Is there a door or window
open?
The current air conditioner
replaced an older model.
The air conditioner is in a
heavily occupied room, or
heat-producing appliances
are in use in the room.
Solution
Plug into a grounded 3 prong outlet. See "Electrical Requirements."
Press and release RESET (listen for click; Reset button will latch and remain in)
to resume operation.
Replace the fuse, or reset the circuit breaker. See "Electrical Requirements."
Press POWER.
Unplug or relocate appliances that share the same circuit.
Replace with a time-delay fuse or circuit breaker of the correct capacity. See
"Electrical Requirements."
Do not use an extension cord with this or any other appliance.
Wait at least 3 minutes after turning off air conditioner before trying to restart
the air conditioner.
the air conditioner.
Press and release RESET (listen for click; Reset button will latch and remain in)
to resume operation.
After correcting the problem, press and release RESET (listen for click; Reset
button will latch and remain in) to resume operation.
NOTE: A damaged power supply cord must be replaced with a new power
supply cord obtained from the product manufacturer and must not be repaired.
Keep doors and windows closed.
The use of more efficient components may cause the air conditioner to run
longer than an older model, but the total energy consumption will be less.
Newer air conditioners do not emit the "blast" of cold air you may be
accustomed to from older units, but this is not an indication of lesser cooling
capacity or efficiency. Refer to the efficiency rating (EER) and capacity rating (in
BTU/hr) marked on the air conditioner.
Use exhaust vent fans while cooking or bathing and try not to use heat-
producing appliances during the hottest part of the day. A higher capacity air
conditioner may be required, depending on the size of the room being cooled.
11