Installation And Connection; Placement Of Your Oven - Panasonic NN-GD36HM Operating Instructions Manual

Installation and Connection

Examine Your Oven
Unpack the oven, remove all packing
material, and examine the oven for any
damage such as dents, broken door
latches or cracks in the door. If you find any
damage, notify your dealer immediately.
Do not install a damaged oven.
Earthing Instructions
If your AC outlet is not grounded, it is the
personal responsibility of the customer to
have it replaced with a properly grounded
wall socket.

Placement of your Oven

This oven is intended for counter-top use
only. It is not intended for built-in use or use
inside a cupboard.
Counter-top Use:
1. Place the oven on a flat and stable
surface more than 85 cm above the
floor.
2. When this oven is installed, it should be
easy to isolate the appliance from the
electricity supply by pulling out the plug
or operating a circuit breaker.
3. For proper operation, ensure a sufficient
air circulation for the oven.
4. Allow 15 cm of space on the top of the
oven, 10 cm at the back, 5 cm on one
side, and the other side must be opened
more than 40 cm.
5 cm
8
EN
15 cm
10 cm
open
Important!
This unit has to be properly earthed
for personal safety.
Operation Voltage
The voltage has to be the same as specified
on the label on the oven. If a higher voltage
than specified is used, it may cause a fire or
other damages.
5. Do not place this oven near an electric
or gas cooker range.
6. The feet should not be removed.
7. This oven is only for household usage.
Do not use outdoors.
8. Avoid using the oven in high humidity.
9. The power cord should not touch the
outside of the oven. Keep the cord away
from hot surfaces. Do not let the cord
hang over the edge of a table or work
top. Do not immerse the cord, plug or
oven in water.
10. Do not block the air vents on the sides
and back of the oven. If these openings
are blocked during operation the oven
may overheat. In this case the oven is
protected by a thermal safety device
and resumes operation only after
cooling down.