Installation Of The Indoor Unit; Connection Of External Water Pump - Gree GMV-ND15G/B6B-T Owner's Manual

NOTES!
① The type of indoor units must be the same if they are controlled by the same wired
controller.
② When the indoor unit is controlled by two wired controllers, the addresses of the two
wired controllers should be different through address setting. Address 1 is for main
controller; Address 2 is for slave controller. Detailed setting please refer to the
instruction manual of wired controller.

5.6 Installation of the Indoor Unit

(1) When routing the piping and wiring from the left or right side of the indoor unit, it is
necessary to cut off the tailings of the pipe left on the holder of the unit. (Shown in
Fig.5.6)
1) Cut down tailings 1 when only the power cord is led.
2) Cut down tailings 1,2 (or 1,2,3) when the connection cord and wire are led.
3) The piping types ① , ② , ③ are recommended.
(2) Let the tubing and cord pass though the piping hole after tied up (refer to Fig .5.6 (d)).
(3) Hang the claw behind the indoor unit on the pothook on the wall panel, and move the
unit left and right to check if the body is firm.
(4) Guarantee that the installation height of the indoor unit should be 2.5m above the
floor.

5.7 Connection of External Water Pump

The external water pump applicable model:
GMV-ND15G/B6B-T,GMV-ND15G/B4B-T,GMV-ND18G/B6B-T,GMV-ND18G/B4B-T,
GMV-ND22G/B6B-T,GMV-ND22G/B4B-T,GMV-ND22G/C4B-T,GMV-ND22G/C2B-T,
GMV-ND22G/D2B-T,GMV-ND28G/B6B-T,GMV-ND28G/B4B-T,GMV-ND28G/C4B-T,
GMV-ND28G/C2B-T,GMV-ND28G/D2B-T,GMV-ND36G/B6B-T,GMV-ND36G/B4B-T,
Multi Variable Air Conditioners Wall Mounted Type Indoor Unit
Fig 5.6
14