Unpacking And Connecting; Unpacking; Assembly - Dirt Devil Antiinfective R1 Operating Manual

2 Unpacking and connecting

2 Unpacking and connecting

2.1 Unpacking

2.2 Assembly

1
2
1
3
2
1
1. Unpack the appliance and all accessory parts.
2. Check the contents are all there. Information regarding
the scope of delivery,
Page 20, "An overview of your
ATTENTION:
Always transport/send the appliance in its original
packaging so that it does not become damaged. Keep
the packing material for this purpose.
Dispose of any packing material that is no longer
required in accordance with the provisions applicable in
your country.
NOTE:
If you should notice damage due to transport, then
contact your dealer immediately.
WARNING:
Only assemble the appliance if the plug has been pulled
out of the socket. The appliance could be switched on by
accident.
1. Push the end of the suction hose (Fig. 2/1) into the
receiver opening (Fig. 2/2) on the cylinder vacuum
cleaner until the lock clicks into place audibly and
Fig.2 noticeably.
2. Push the handle (Fig. 3/1) into the upper end of the
4
telescopic tube (Fig. 3/2).
3. Push the floor nozzle (Fig. 3/3) onto the lower end of the
telescopic tube (Fig. 3/4).
NOTE:
It may be necessary to push a bit harder.
Fig.3
4. Adjust the length of the telescopic tube. To do this,
press the telescopic tube lock (Fig. 4/1) down. Then pull
the telescopic tube by the handle (Fig. 3/1) to the
desired length. To lock it, release the telescopic tube
lock when you let go. You will hear an audible click.
Your cylinder vacuum cleaner is now ready to use.
Fig.4
".
25