Flash Setting - Geemarc 250 User Manual

3 - Flash setting

Your telephone flash time is factory set for the UK ( R=100ms)
Don't change this
But sometimes if your phone is connected to a private network it might be
changed , so proceed as below :
Use and to select "BS setting" , then Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it , then Press OK
Use and to select "Flash Time" , then Press OK
Use and to choice 300 or 600ms, then Press OK
Press twice C or once
4 - Insert a pause
-If you need to insert a pause between the digits you dial , you can set the time of
this pause : 2,3 or 4secs
Use and to select "BS setting" , then Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it , then Press OK
Use and
Use and to choose the time , then Press OK
Press twice C or once
to return to standby mode
to select "Pause Time" , then Press OK
to return to standby mode
23
Base Setting