NETGEAR R6000 User Manual page 88

3. Select the Enable Access Point Mode check box.
The AP Mode section of the screen expands.
4. Select the check box for the IP address setting that you want to use:
• Get an IP address dynamically from the other router. The other router on the
network assigns an IP address to this router while this router is in AP mode.
• Fixed IP address (not recommended). Use this setting if you want to manually
assign a specific IP address to this router while it is in AP mode. Using this option
effectively requires advanced network experience.
Note: If the other router or gateway in your network also has wireless
capability, NETGEAR recommends that you use wireless settings on your
router that are different from those on the other router or gateway to avoid
interference. You could also disable the wireless radio on the other router or
gateway and use your router only for wireless client access.
5. Click the Apply button.
The IP address of the router changes, and you are disconnected. To reconnect, close and
restart your web browser, and type http://www.routerlogin.net.
R6000 WiFi Router
Advanced Settings
88