Yamaha CVP-109 Reference Booklet page 61

• AC power cord
• 4 x 12 mm small screws x 4
• 5 x 12 mm large screws x 30
Downloaded from: http://www.usersmanualguide.com/
2
• Blanket, etc.
X
Carefully lean the main unit against a wall.
To make it easier to install the legs, place a soft blanket or simi-
lar material on the floor near a wall, close the Clavinova key-
board cover, place the front panel of the Clavinova (the side
with the keyboard) on the blanket and gently lean the unit
against the wall — MAKING SURE THAT IT CAN NOT
FALL — as shown in the illustration.
CAUTION
• Do not lay the main unit upside-down on the floor.
C
Pedal assembly.
A: Under the pedal box, remove the vinyl tie from the pedal
cable (the illustration shows the tie removed). Paying close
attention to the direction of the rear legs (take note of the leg
brackets in the illustration), slide the pedal box onto the left leg.
B: Align the cut hole in the pedal box with the hole in the left
leg and insert the cable into the hole on the left leg, pull the
cable out of the top of the left leg.
C:
Align the screw holes, attach the two 4 x 12 millimeter small
screws to 2 locations. (First tighten both screws loosely, once the
position has been determined tighten firmly.)
Use the same procedure (A, B and C) to attach the right
leg.(However, the right leg is not equipped with a pedal cord.)
CAUTION
• When you lift the pedal box assembly, make sure that you lift by
both legs.
3
A
• Right leg
• Left leg
CVP-109/107/105/103/700
B
C
61