Makita DSP600 Instruction Manual page 10

► 1 . Lever
-1°-bevel cutting
To perform -1°-bevel cutting, loosen the clamping screws and
press the levers toward the direction of the arrow in the figure.
Then set the bevel angle to -1° and tighten the clamping screws.
► 1 . Lever
Sighting
1
► 1 . Base
The cutting line varies depending on the cutting angle
and whether you use the guide rail (optional accessory).
When using the tool without guide rail
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
When using the tool with guide rail
For both straight cuts and 45° bevel cuts, always align the
A position on the front of the base with your cutting line.
1
A B
Switch action
WARNING:
the tool, always check to see that the switch trigger actuates
properly and returns to the "OFF" position when released.
WARNING:
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
simply pull the switch trigger without pressing the lock-off
button. A switch in need of repair may result in unintentional
operation and serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE further usage.
To prevent the switch trigger from being accidentally pulled, a lock-
off button is provided. To start the tool, depress the lock-off button
and pull the switch trigger. Release the switch trigger to stop.
1
2
1
► 1 . Switch trigger 2. Lock-off button
NOTICE:
Do not pull the switch trigger hard without
pressing in the lock-off button. This can cause switch breakage.
Speed adjusting dial
The tool speed can be adjusted by turning the adjusting
dial. The speed of the blade rotation increases as you
increase the number on the speed adjusting dial.
► 1 . Speed adjusting dial
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
10 ENGLISH
Before installing the battery cartridge into
NEVER defeat the lock-off button
NEVER use the tool if it runs when you
1