Advertisement

Quick Links

PLR36M
OWNER'S MANUAL
Mobile Audio System
 PLL Synthesizer Stereo Radio
 Automatic Memory Storing
 USB Interface
 SD Interface
 3.5mm Input Jack
www.pyleaudio.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PLR36M and is the answer not in the manual?

Questions and answers

Summary of Contents for Pyle PLR36M

  • Page 1 PLR36M OWNER’S MANUAL Mobile Audio System  PLL Synthesizer Stereo Radio  Automatic Memory Storing  USB Interface  SD Interface  3.5mm Input Jack www.pyleaudio.com...
  • Page 2: Table Of Contents

    CONTENTS Installation ........... 3 Take out screw before installation ..3 DIN Front-Mount ......... 3 Installing the unit ....... 3 Removing the unit ......4 Wiring Connection ......5 Operation ..........6 Location of keys ........6 Switching on/off the unit ......7 Sound adjustment .........
  • Page 3: Installation

    INSTALLATION Notes: Be sure you test all connections first, and  Choose the mounting location where then follow these steps to install the unit. the unit will not interfere with the 1. Make sure the ignition is turned off, and normal driving function of the driver.
  • Page 4 INSTALLATION 3. Lift the top of the outer trim ring then pull it out to remove it. 4. Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard.
  • Page 5: Wiring Connection

    WIRING CONNECTION ISO CONNECTION...
  • Page 6: Operation

    OPERATION LOCATION OF KEYS seek down button 8. USB interface seek up button 9. Reset button 3. MOD 10. VOL/SEL/PWR 4. LCD 11. AUX IN 5. BND/AS/SCH 12. SD interface 6. CLK 13. IR / SAVE...
  • Page 7: Switching On/Off The Unit

    OPERATION SWITCHING ON/OFF THE UNIT RESET button (9) must be activated with Press PWR button (10) to turn on the unit. either a ballpoint pen or thin metal object. When the unit is on. Press and hold for 2 The RESET button is to be activated for the seconds to turn off the unit.
  • Page 8: Automatic Memory Storing& Program Scanning

    OPERATION  AUTOMATIC MEMORY STORING & USB mode. PROGRAM SCANNING It supports the MP3/WMA file in the device. - Automatic memory storing The operation please refer to the following Press AS button (5) for 2 seconds, the instruction. radio searches from the 87.5MHz frequency and checks the signal SELECTING SONGS IN SINGLE STEP strength until one cycle search is...
  • Page 9 OPERATION CAUTION: When there are important files in the USB Device or SD card, do not connect it to the main unit to play, because any wrong operation may cause files loss. And our company assumes no responsibility for this.
  • Page 10: Remote Control

    REMOTE CONTROL (OPTIONAL) FUNCTION KEY & CONTROL Power ON/OFF Button. 2. VOL+ Volume up button. 3. BAND Band Select Button. 4. SEL Sound Mode Select Button Radio mode: seek/turn down station. MP3 mode: skip to the previous file or fast reverse 6.
  • Page 11: Specification

    SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 64 (D) x 50 (H) Tone Controls : ±10 dB Bass (at 100 Hz) : ±10 dB Treble (at 10 kHz) Maximum Output Power : 2x3 watts Current Drain: 3Ampere (max.)
  • Page 12: Trouble Shooting

    TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom Cause Solution The car ignition switch is power supply No power. not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key...

Table of Contents