Table of Contents
Advertisement
Note
f The remote control can be used within a distance of about 15 m (49'2") if pointed directly at the remote control receiver. The remote control
can control at angles of up to ± 15° vertically and ± 30° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.
Projector body
Front
1
2
3
4
5
Rear
8
Bottom
8
Front
1
Power indicator <ON (G)/STANDBY (R)>
Displays the status of the power.
2
Light source indicator <LIGHT>
Displays the status of the light source.
22 - ENGLISH
Chapter 1 Preparation — About your projector
6
7
4
5
8
9
9
17
Side
10
11
12
13
14
8
Front
15
16
3
Temperature indicator <TEMP>
Displays the internal temperature status.
4
Adjustable feet
Adjusts the projection angle.
5
Remote control signal receiver
6
Projection lens
7
Lens shift lever
Adjusts the projection position.
8
Air intake port
9
Air exhaust port
10 Security slot
This security slot is compatible with the Kensington security
cables.
11 Connecting terminals (x page 23)
12 <AC IN> terminal
Connect the supplied power cord.
13 <MAIN POWER> switch
Turns on/off the main power.
14 Focus ring
Adjusts the focus.
15 Zoom ring
Adjusts the zoom.
16 Control panel (x page 23)
17 Burglar hook port
Attaches a burglar prevention cable, etc.
Front
9
Advertisement
Table of Contents
