Table of Contents
Advertisement
Note
f When using only one projector, the value obtained by subtracting the value of the [BRIGHTNESS CONTROL GAIN] from 100 % is the
maximum amount of brightness correction. Brightness cannot be corrected through brightness control since the maximum amount of
correction becomes 0 % when [BRIGHTNESS CONTROL GAIN] is at 100 %.
f Brightness is not stable for 15 minutes after the light source lights up. Make adjustments at least 15 minutes after starting projection.
f The result of [BRIGHTNESS CONTROL GAIN] adjustments is reflected on all image signals, internal test patterns, and on-screen menus.
f [BRIGHTNESS CONTROL GAIN] is enabled even if [BRIGHTNESS CONTROL GAIN] is [OFF].
Setting [BRIGHTNESS CONTROL SETUP]
Set brightness control operation.
1)
Press as to select [BRIGHTNESS CONTROL].
2)
Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3)
Press as to select [BRIGHTNESS CONTROL SETUP].
4)
Press the <ENTER> button.
f The [BRIGHTNESS CONTROL SETUP] screen is displayed.
5)
Press as to select [MODE].
6)
Press qw to switch [MODE].
f The items will switch each time you press the button.
[OFF]
[AUTO]
[PC]
*1 "Multi Projector Monitoring & Control Software" is included in the supplied CD-ROM.
f When [AUTO] is selected, proceed to Step 7).
7)
Press as to select [LINK].
8)
Press qw to switch [LINK].
f The items will switch each time you press the button.
[OFF]
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
9)
Press as to select [CALIBRATION TIME].
10) Press the <ENTER> button.
11) Press qw to select the hour and minute, press as to set the time, and press the <ENTER> button.
f If you do not specify the time, select [OFF] between 23 and 00 o'clock or between 59 and 00 minutes.
f Brightness is measured at the specified time. During measurement, [LIGHT POWER] in [ECO MANAGEMENT] is fixed to [NORMAL].
Also, [AUTO POWER SAVE] is fixed to [OFF].
12) Press as to select [CALIBRATION MESSAGE].
13) Press qw to switch [CALIBRATION MESSAGE].
f The items will switch each time you press the button.
[ON]
[OFF]
14) Press as to select [APPLY].
80 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Does not correct the brightness of the screen by the brightness sensor.
Corrects the brightness of the screen by the brightness sensor.
When the brightness of the light source changes, the brightness of the screen is automatically
corrected.
Synchronizes nine or more projectors through a computer using the dedicated software "Multi
Projector Monitoring & Control Software"
Performs corrections by the brightness sensor in one projector without synchronizing with the other
projectors.
The period, in which the constant brightness kept by the small value of [BRIGHTNESS CONTROL
GAIN], is prolonged.
Synchronizes corrections in multiple projectors by the brightness sensor.
You can set up to four groups (A to D) within the same subnet by using the network function.
You can also register and synchronize up to eight projectors in one group.
Messages are displayed during calibration.
Messages are not displayed during calibration.
.
*1
Advertisement
Table of Contents
