Table of Contents
Advertisement
DEINTERLACE
ON
OFF
1
COLOR SYSTEM*
VIDEO, S-VIDEO inputs only
AUTO
NTSC
PAL
SECAM
4.43 NTSC
PAL-60
OVER SCAN
HDMI, Y/Pb/Pr, SCART*
1
, VIDEO*
1
, S-VIDEO*
1
,
HDMI2*
1
, HDMI3*
1
inputs only
ON
OFF
OPTION SETTING
OPTION POWER
AUDIO*
1
INTERNAL PC*
1
OFF WARNING
AUTO OFF
START UP PC
FORCE QUIT
120Hz
TOUCH PANEL
(not adjustable)
RESET
*1: This function depends on which option board you use.
Selects the IP (Interlace to Progressive) conversion function.
NOTE: For DVI input "DVI-HD" needs to be enabled in the DVI mode menu. When INPUT2 of
SUPER is selected in INPUT CHANGE and displayed, this function cannot be changed.
Converts interlaced signals to progressive. This is the default setting.
Disables IP conversion. This setting is best suited for motion pictures, but increases the risk of
image retention.
The selected Color System depends on the video format of the input signal.
Automatically chooses Color System setting based on input signal.
Some video formats may require different scanning modes in order to best display the image.
Image size is larger than what can be displayed. The image edge will appear cropped.
Approximately 95% of the image will be shown on the screen.
Image size stays within the display area. The whole image is displayed on the screen.
NOTE: When you use a computer with HDMI out, please set "OFF".
Allow the monitor to supply power to Option board slot during power save mode or standby
mode.
NOTE: This function should be set to ON when using power save management by slot 2 type
option.
Selects sound input signal according to slot2 type option's specifi cations. To activate DIGITAL,
select OPTION for input signal and OPTION for AUDIO INPUT.
NOTE: DIGITAL is activated only when OPTION is selected for input signal and OPTION for
AUDIO INPUT.
The function is available for slot 2 type PC.
If OPTION POWER is OFF, a warning message appears when monitor power is turned off.
NOTE: Warning message does not appear when monitor power is turned off by OFF TIMER
setting or SCHEDULE setting.
Monitor power is automatically "OFF" when connected PC is OFF or the monitor is in power save
mode.
NOTE: Monitor power is not automatically "ON" when connected PC is ON.
When ON is selected, connected PC start-up.
When ON is selected, it performs force-quit PC.
Please use this function only when the operating system cannot be shut down manually.
When on, this function provides a smoothing effect to video by automatically estimating and
compensating for motion. However, based on the selected input signal, an abnormal picture may
result. In this instance, select OFF.
Resets the following settings within the ADVANCED OPTION menu back to factory setting:
INPUT DETECT (except the priority of input signals), INPUT CHANGE (except for INPUT1 and
INPUT2), TERMINAL SETTING, DEINTERLACE, COLOR SYSTEM, OVER SCAN, AUDIO in
OPTION SETTING.
English-28
ON
AUTO
ON
-
OFF
ANALOG
OFF
OFF
NO
NO
Depends on
signal input
-
-
Advertisement
Table of Contents
