Electrolux EFMG417SIW0 Installation Instructions Manual page 15

Water connection (Steam Model only)
WATER SUPPLY REQUIREMENTS
Cold water faucet MUST be installed within 42
inches (107 cm) of your dryer's water inlet. The
faucet MUST be 3/4 inch (1.9 cm) with thread-
ing for laundry hose connection. Water pressure
MUST be between 20 and 120 psi. Your water de-
partment can advise you of your water pressure.
1. Turn off COLD water supply to washer,
2. Remove COLD inlet hose from COLD water
supply and inspect for rubber washer.
Replace washer if it is torn or worn out.
RUBBER WASHER
MUST BE PRESENT
AND UNDAMAGED
COLD INLET HOSE
TO WASHER
3. Momentarily turn on COLD supply and run
some water into a bucket or container to
clear any contaminants in the line.
4. Remove hose kit from dryer drum and
inspect hose couplings for proper
placement of rubber washers.
Installation Instructions
RUBBER WASHERS
MUST BE PRESENT
15