Table of Contents
Advertisement
H
ow to use washer
Refresh
I Refresh cycle
• For slightly wrinkled clothes which have
been stored for an extended time.
This cycle makes wrinkled clothes easy to
iron (Do not load wet clothes).
• Wrinkles will be reduced.
I How to use Refresh cycle
1. Turn on the washer and select the Refresh
program.
2. Load 5 items or less and close the door.
3. Press the Steam button repeatedly until the
required and correct number of items is
displayed
4. Press the start/Pause button
[Precautionary Notes]
- The Refresh cycle is not like other washing
or drying cycles.
- After the Refresh cycle is complete, the
washer will tumble the clothes for up to 30
minutes to prevent rewrinkling.
- Due to the characteristic of cotton fibers,
this cycle is not recommended for 100%
cotton clothing.
- Remove stains from clothing before using
the Refresh cycle to prevent permanently
setting the stains by high heat.
- Be sure that the tap is open. This cycle
uses a little water to produce steam.
- Be careful not to touch the door. It can be
very hot.
- Do not open the door while operating.
Steam can cause severe burns.
- After removing clothes from the Refresh cycle
they may feel slightly damp wait at least 10
minutes before putting the clothes on.
- Best result are achieved when articles are
of similar size and fabric type. Do not
overload (avoid loading more than 3 dress
shirts if loading up to 5 Items.)
CAUTION
!
- Do not reach into the washer while
operating. Steam can cause severe burns.
- Keep pets away from the washer.
Door Lock
• Lights whenever the door of the washer is
locked.
• The door can be unlocked after a 2~3
minute delay, pressing the Start/Pause
button to stop the washer.
Detecting
• While the "Detecting" is shown in the
display the machine rotates slowly and
detects how many laundries are loaded in
the drum. It will take a few seconds.
23
Advertisement
Table of Contents
