Furuno MFD8 Installation Manual page 38

Note: The DVI and VGA Vertical frequency output is 60Hz on the MFDBB.
When two monitors are connected to the MFDBB, you can choose to configure the
monitors either in Clone Mode or in Extended Mode.
Note: When two monitors are connected to the MFDBB processor unit, they need to be
capable of displaying the same resolution. The MFDBB cannot output a different
resolution on each port.
When Extended Mode is used the two screens need to be located in close proximity to
each other (Side-by-Side). The two monitors will show two different screen displays that
can be configured independently. Only one Keyboard is used to control both monitors
(the cursor will "jump" back and forth from monitor to monitor).
Clone mode is selected when either one or two monitors are installed for separate
station configurations. A dual station requires a dual keyboard installation from one
processor unit. In this case both monitors will show the same picture information.
Furuno offers the following DVI cable:
- 5 Meter DVI Cable (FUSA P/N= 000-149-054)
- 10 Meter DVI Cable (FUSA P/N= CBL-DVI-10M)
Note: All the DVI cables provided by Furuno are single link DVI-D Cables
38