Solving Problems; Common Problems - Dell 2709WFP User Manual

Hide thumbs

Table Of Contents

Table of Contents

Back to Contents Page

Solving Problems

Dell™ 2709W Flat Panel Monitor User's Guide

Monitor Specific Troubleshooting

Common Problems

Video Problems

Product Specific Problems

Universal Serial Bus (USB) Specific Problems

Troubleshooting the Dell™ Soundbar (Optional)

Card Reader Troubleshooting

CAUTION:

Before you begin any of the procedures in this section, follow the

Troubleshooting Your Monitor

Self-Test Feature Check (STFC)

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly

connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:

1. Turn off both your computer and the monitor.

2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue

connector) cables from the back of computer.

3. Turn on the monitor.

The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.

While in self-test mode, the power LED remains blue. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll

through the screen.

4. This box also appears during normal system operation if the video cable becomes disconnected or damaged.

5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after you use the previous procedure, check your video controller and computer system, because your monitor is

functioning properly.

NOTE:

Self test feature check is not available for Composite, and Component video modes.

OSD Warning Messages