NEC N8190-171 Manual page 40

(1) PCI Express connector
Connector to be inserted into the PCI slot of the computer.

This product's PCI Express connector type is x8.
Tips
(2) Bracket
Bracket to fix this product to the extended slot of Computer.

When fixing this product to a PCI slot optimized for the low profile type, replace the
Tips bracket with the attached low profile one.
(3) SFP+ Module
Module to transmit and receive Fibre Channel signals. Need to remove temporarily when exchange a
bracket or install this product into computer.

Don't insert the SFP+ module of this product to the other port or the other Fibre
Notice
Channel device.
(4) LED (Port1/Port2)
Two LED for each port (Port0/Port1) give a visual indication of the operating state.
The slow blink rate is 1Hz; the flashing state is an irregular on/off appearance reflecting program
activity.
Green LED
Off
Off
Off
Off
On
On
On
On
On
Slow Blink
 If the product fails at POST, please check the following items.
- Is the product installed in the computer correctly?
Notice
- Are all Fibre Channel cables and power cords connected correctly?
(5) Fibre Channel Connector
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(6)IEEE Address
IEEE Address of Port0 is displayed by this label.

The IEEE address of Port1 is the next successive number of the Port 0.

The IEEE address correspond to the lower 12 figures of Worldwide Name(WWN)
Tips
address.
Yellow LED
Off Boot Failure (Dead Board)
On POST Failure (Dead Board)
Slow Blink Boot Failure after POST
Flashing POST Processing in Progress
Off Failure While Functioning
On Failure While Functioning
Blink(3 beat) 8Gbps Link Rate – Normal, link up (not supported)
Blink(4 beat) 16Gbps Link Rate – Normal, link up
Blink(5 beat) 32Gbps Link Rate – Normal, link up
Off Normal – Link Down
- 38 -
State