Table of Contents
Advertisement
ASSEMBLY & SET-UP INSTRUCTIONS
UNPACKING THE CONTAINER
WARNING! Use extreme caution unpacking this machine. Some components are very heavy and will require
additional people or mechanical handling equipment.
NOTE: All references in this manual to the left or right side and front or back of the log splitter are from the operating
position only. Exceptions, if any, will be specified.
Unpacking tools needed:
1. Wrench 14mm
2. Scissors or knife
3. Pry bar or claw hammer
Step 1: Use a 14mm wrench to remove all the bolts and washers on the metal crate, put aside the packing top and side
frames, then remove the cardboard box. See FIGURE 3.
(FIGURE 3)
Cardboard box
Beam / Frame Top Assembly
Page 10
Crate Bottom
Crate Top
Flat Washer x 48PCS
Crate Side Frame x 8PCS
Hex Head Bolt
x 48PCS
Page 7
Advertisement
Table of Contents
