Table of Contents
Advertisement
Rear
Exhaust vent
Heated aiir is exhausted
from here.
(→ page xi, 155)
Built-in Security Slot ( )*
Terminals
(→ page 9)
* This security slot supports the MicroSaver
Security Bar
Fixing a theft prevention
device.
The security bar accepts
security wires or chains
up to 0.18 inch/4.6 mm in
diameter.
Handle (located on 4 posi-
tions)
For transportation
NOTE:
• For moving the projector,
make sure you have at least
two people. At the same
time, do not grip and hold
the projector other than by
these handles. Attempting
to move the projector alone
could result in back pain or
other injuries.
Security System.
®
7
1. Introduction
Controls
(→ page 8)
AC IN terminal
Connect the supplied
power cord's three-pin
plug here, and plug the
other end into an active
wall outlet. (→ page 14)
Power Cord Stopper
(→ page 16)
Main power switch
While AC power is being supplied, set the
main power switch to ON position (|), then
your projector will enter a standby state.
Theft prevention screw
hole for the lens unit
Intake vent
Takes in air to cool the unit.
(→ page xi, 155)
Advertisement
Table of Contents
