Table of Contents
Advertisement
2. Adjust the focus at the edges of the projected image.
Press either the ZOOM +/− button on the control panel or the D-ZOOM/ZOOM +/− button while holding to press
the CTL button on the remote control until you can obtain the best focus at the edges of the projected image.
(The ZOOM adjustment bar will be displayed on.)
Focus around the optical axis set at step 1 is remained unchanged.
3. Repeat steps 1 and 2 until the optimal focus can be obtained on whole image.
TIP:
To obtain the best focus, perform the following (for permanent installation)
Preparation: Warm up the projector for one hour.
1. Use the FOCUS +/− buttons to make sure you obtain the best focus. If you do not, move the projector back
and forth.
2. Select the [TEST PATTERN] from the menu and display the test pattern. (→ page 88)
• You can also use the TEST button on the remote control to display the test pattern.
3. Keep pressing the FOCUS − button until the grid of the text pattern is made invisible.
• The FOCUS adjustment bar displaying position can be shifted or be turned off temporarily. (→ page 36, 37)
4. Keep pressing the FOCUS + button until you obtain the best focus.
If you adjust beyond the best focal point, go back to step 3 and repeat the procedures.
5. Press the ZOOM +/− button for adjusting the edges of the projected image.
Press the D-ZOOM/ZOOM +/− button holding to press the CTL button for adjusting it by the remote control.
Repeat steps 1 to 5 until the optimal focus can be obtained on whole image.
2. Projecting an Image (Basic Operation)
Optical axis
30
Advertisement
Table of Contents
