Do you have a question about the Therapure TPP630 and is the answer not in the manual?
Questions and answers
Anna Squillante
February 13, 2025
The reset light for UV does not light after replacing UV bulb. I followed the manual instructions.
1 comments:
Mr. Anderson
February 13, 2025
After replacing the UV bulb on the Envion Therapure TPP630, the reset light may not turn off because the reset procedure has not been completed. To reset the unit, plug it in and hold down the UV/VOC button for 3 seconds. This will turn off the clean filter light and complete the maintenance process.
TABLE OF CONTENTS SAFETY INSTRUCTIONS IMPORTANT WARNINGS UV Lamp Notice Thank you for purchasing the Therapure ® Mercury Notice 630 air purifier. With UV light and UV Lamp Disposal Notice cleanable HEPA-Type filtration to clean UV Lamp Breakage the air, the Therapure 630 air purifier will ®...
» Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Envion is required to provide the following warning: Arrange cord away from traffic area and where it will not be tripped over.
Page 5
OPERATING THE THERAPURE TPP630 OPERATING THE THERAPURE TPP630 ® ® Before using the Therapure ® 630 air purifier, please read the following important information. Before using the Therapure 630 air purifier, please read the following important information. ® Safety Electrical Ratings: Do not place near fans.
OPERATING THE THERAPURE TPP630 CLEANING & MAINTENANCE ® CONTROLS/SETTINGS: Keep the Therapure ® 630 functioning properly by cleaning the cleanable HEPA-Type Filter every four weeks of use. More frequent cleaning will be necessary if the unit is located in an area with a high level of airborne contaminants (excessive amounts of smoke, pet dander, etc.).
CLEANING & MAINTENANCE CLEANING & MAINTENANCE Cleaning the Pre-Filter Before replacing the UV lamp, make sure the Therapure 630 air purifier is turned ® off and unplugged. Let the lamp cool down for 5 minutes before replacing it. Release the air inlet grill by pressing on the locking latch.
TROUBLESHOOTING ONE-YEAR LIMITED WARRANTY ONE YEAR LIMITED WARRANTY PROBLEM REASON SOLUTION Your Therapure 630 air purifier is warranted to be free from defects in materials and workmanship ® for one year from the original purchase date. Should the product have a defect in materials or workmanship, we will repair or replace it without charge to you (a shipping and processing fee will Unit will not Control Dial has not been...
ARBITRATION AGREEMENT PLEASE READ THIS AGREEMENT CAREFULLY. YOU ACCEPT THE TERMS OF THIS AGREEMENT BY RETAINING THE PRODUCT(S) SHIPPED IN CONNECTION WITH THIS AGREEMENT (THE “PRODUCTS”) FOR MORE THAN THIRTY (30) DAYS AFTER RECEIPT. IF YOU DO NOT AGREE TO THE TERMS OF THIS AGREEMENT, YOU MAY RETURN THE PRODUCT TO COMPANY WITHIN THIRTY (30) DAYS OF RECEIPT FOR A FULL REFUND.
Need help?
Do you have a question about the Therapure TPP630 and is the answer not in the manual?
Questions and answers
The reset light for UV does not light after replacing UV bulb. I followed the manual instructions.
After replacing the UV bulb on the Envion Therapure TPP630, the reset light may not turn off because the reset procedure has not been completed. To reset the unit, plug it in and hold down the UV/VOC button for 3 seconds. This will turn off the clean filter light and complete the maintenance process.
This answer is automatically generated