Controller Features & Settings - Haier AW12EH2VHA User Manual

Remote Controller
7
2
3
4
9
11
15
13
17
18
1 Power Button
Press the ON/OFF button on the remote control to start
the unit.
2 TURBO/QUIET Button
The TURBO function is used for fast heating or cooling.
Press the TURBO/QUIET
control will display the TURBO
side of the remote display and switch the unit to the TURBO
function.
The QUIET function may be used when silence is needed for
fast rest or reading. Press the TURBO/QUIET
again to switch to QUIET mode and the remote control will
display the QUIET icon on the bottom left side of the
remote display.
Press the TURBO/QUIET
TURBO/QUIET and return to normal operation.
PAGE 2
1
5
6
10
8
12
14
16
19
button once and the remote
icon on the bottom right
button
button a third time to cancel
CONTROLLER FEATURES & SETTINGS
Note:
TURBO/QUIET modes are only available when the unit is un-
der cooling or heating mode (not for auto or fan mode).
Running the unit in QUIET mode for a long period of time
may cause the room temperature to not reach the set
temperature. If this occurs, cancel QUIET mode and set the
fan speed to a higher setting.
3 COOL Button
In COO mode, the unit operates in cooling. When FAN is
set to AUTO, the air conditioner automatically adjusts the
fan speed according to room temperature. The
displayed during COOL mode.
4 HEAT Button
In HEAT mode, warm air will blow out after a short period of
the time due to cold-air prevention function. When FAN is
set to AUTO, the air conditioner automatically adjusts the
fan speed according to room temperature. The
displayed during HEAT mode.
5 DRY Button
DR mode is used to reduce humidity. In DR mode, when
room temperature becomes lower than temp. setting 2 F,
unit will run intermittently at LOW speed regardless of FAN
setting. The will be displayed during DR mode.
6 Temperature +/- Buttons
Temp Every time the button is pressed, the temperature
setting increases.
Temp - Every time the button is pressed, temperature
setting decreases.
The operating temperature range is 60 F-86 F (16 C-30 C).
7 AUTO Button
Under the mode of auto operation, the air conditioner will
automatically select Cool, Heat, or Fan operation according
to set temperature. When FAN is set to AUTO the air condi-
tioner automatically adjusts the fan speed according to room
temperature. The will be displayed during AUTO mode.
8 FAN Button
Fan speed selection
Press the FAN button. For each press, fan speed changes
as follows:
Remote control:
Display
circulated
LOW MED HI AUTO
The air conditioner fan will run according to the displayed fan
speed.
When FAN is set to AUTO, the air conditioner automatically
adjusts the fan speed according to room temperature.
9 Louver SWING Button - Vertical
will be
will be