Table of Contents
Advertisement
WIND DIRECTION DISPLAY TYPE SETTING
The wind direction can be displayed using either compass directions or degree
measurements (default setting is compass directions).
RESET PROCEDURE. SEE WARNINGS in the FACTORY RESET section.
FACTORY RESET PROCEDURE
WARNING:
Performing a factory reset will erase all MIN/MAX values and weather data stored
in the display's internal memory and return the weather units settings back to the factory
defaults. If you have not yet uploaded the data to the Heavy Weather Pro software, the
data will be lost.
If you do not wish to reset the display to factory defaults either:
• Press the MIN/MAX key or the ALARM key, or
• Simply wait until the SET mode times out and returns to the Mode 1 display
(normal mode).
To reset the display to factory defaults, follow the procedure below:
WARNING:
A factory reset will erase the connection between the display and the thermo-
hygro sensor and require the connection to be re-established.
the thermo-hygro sensor, making sure to align the "+" symbol on the batteries
with the markings on the battery cover and inside the battery compartment.
1. The wind direction will start flashing.
2. Press the ▲UP ARROW key or ▼DOWN ARROW
key to toggle from compass directions to degree
measurements.
3. If you do not wish to reset the display to factory
defaults, simply press the ALARM or MIN/MAX key, or
wait until the SET mode times out and returns to the
normal display mode.
4. If you wish to perform a FACTORY RESET, press the
SET key to confirm and to enter the FACTORY
1. "rES oFF" will start flashing.
2. Use the ▲UP ARROW key to turn "rES on".
3. Press the SET key to confirm and a countdown timer
will begin counting down from "127". When the timer
displays "dOnE", you must remove the batteries from
the display for 10 minutes. While the batteries are out
of the display, also remove the batteries from the
thermo-hygro sensor.
4. After waiting for 10 minutes, insert the batteries into
48
Advertisement
Table of Contents
