Door Alignment - LG LSC27921SB Owner's Manual

Reinstalling the left (freezer) door
(2 )
(1 )
(4)
(5)
(6)
(7)
Type 1
1. Feed the water tubes through the lower hinge pin and
place the door onto the lower hinge pin.
2. Fit top hinge (6) over hinge lever latch (7) and into
place. Rotate lever (5) clockwise to secure hinge.
NOTE: Regardless of hinge lever type, reinstallation
process is the same.
3. Install the grounding screw (4) and connect all the
wire harnesses (3).
4. Hook tab on door switch side of cover (2) under
edge of wire opening in cabinet top. Position cover
into place. Insert and tighten cover screw (1).
5. Reconnect the water tubes by inserting the tubes
into the connectors.
Collet
Tube
Insert Line

DOOR ALIGNMENT

Remove the base grille before adjusting the doors.
See BASE GRILLE INSTALLATION for reference.
Two methods of door alignment are available based
on the amount of adjustment needed and installation
requirements.
Type 1
Adjusting tool: Flat blade screwdriver
If the freezer compartment door is lower than the
refrigerator compartment door, level them by inserting
a flat blade screwdriver into the groove of the left
leveling leg and rotating it clockwise.
Left
leveling leg
If the freezer compartment door is higher than the
refrigerator compartment door, level them by
inserting a flat blade screwdriver into the groove of the
right leveling leg and rotating it clockwise.
REFRIGERATOR INSTALLATION
(3)
(7)
(5)
(6)
Rivet
Type 2
Height
difference
Height
difference
F C CF C F H
Height
difference
F C CF C F H
Type 2
Adjusting tools: 5/16" (8 mm) wrench and 3/4"
(19 mm) wrench
Height
difference
Height
difference
C CF F C H F
Using a 3/4" (19 mm) wrench, turn the keeper nut
clockwise to loosen the keeper nut.
Using a 5/16" (8 mm) wrench, turn the adjustment
hinge pin clockwise or counterclockwise to level the
refrigerator and freezer door.
After setting level door, turn the keeper nut
counterclockwise to tighten.
CAUTION:
Do not overtight the door adjustment
screw. The hinge pin can be pulled out. (Adjustable
range of height is a maximum of 1/2" (1.27 cm)).
AFTER LEVELING THE DOOR HEIGHT
Confirm all legs are in contact with the floor.
9
Right
leveling leg
Height
difference
Keeper Nut
Wrench
Up
Adjustment
hinge pin
Down