Care and Cleaning 17-19 Important Safety Instructions General Cleaning Tips Grounding Requirements Outside Refrigerator Features Inside Walls Refrigerator Installation Door Liners and Gaskets Unpacking you Refrigerator Plastic Parts Installation Back Cover Base Grille Installation Lamp Replacement Handle Removal Power Interruptions Removing and Replacing Refrigerator Doors When you go on vacation Door Alignment...
Thisguidecontains manyimportant safetymessages. Always readandobey. Thisisthesafetyalertsymbol. I talertsyouto safety messages t hatinform youof hazards thatcan killor hurtyouor others, o rcausedamage totheproduct. Allsafetymessages will bepreceded by thesafety alertsymbol andthehazard signal w ordDANGER, WARNING, or CAUTION. These wordsmean: [] BANGER Youwilldekilled orseriously injured ifyoudon't f ollow instructions. WARNING You can be killed or seriously injured if you don't follow instructions.
Ir!_ [__ li!!,,-,]:l[o]i {o} I II! p]1:1 l i / _!_,I I _v_i :1l i d Child entrapment and suffocation are not problems of Before you throw away your old the past. Junked or abandoned refrigerators are still Refrigerator or freezer: •...
Usethispagetobecome morefamiliar w iththeparts andfeatures. P agereferences a reincluded foryour convenience. Note:Thisguidecoversseveral different m odels.The r efrigerator youhavepurchased m ayhavesomeor alloftheitemslisted below. T helocations o fthefeatures shown belowmaynotmatch yourmodel. O Freezer D oorRack Dairy Corner For storage of dairy products utomatic Ice Maker such as butter and cheese.
INSTALLATION 1. Avoid placing unit near heat sources, direct sunlight or Excessive Weight Hazard moisture. Use two or more people to move and install 2. To minimize noise and vibration, the refrigerator Refrigerator. MUST be installed on a solidly constructed floor. Failure to do so can result in back or other injury.
NOTE: I t isALWAYS recommended to remove the REMOVING AND REPLACING refrigerator doors whenit isnecessary t o movethe REFRIGERATOR DOORS refrigerator through a narrow opening. I f necessary, follow thedirections b elowtoremove thedoorhandles. Remove water feed tube • Remove the block from connector (1). Removing Base Grille •...
Page 8
To remove the right refrigerator door: /(2) /(2) )_(5) L)_(4) (5) I_ Left Door 1. Open the door. Remove the top hinge cover screw 1. Feed the water tubes through the lower hinge pin and (1). place the door onto the lower hinge pin. 2.
DOOR ALIGMENT Adjust the level when the refrigerator door is lower than the freezer door during the installation of the refrigerator. Before adjust the doors, remove the Base Grille. See BASE GRILLE INSTALLATION for reference. Tools you need - Wrench 5/16 in (8 mm) If the freezer compartment door is lower than the refrigerator compartment door, make them...
ENSURING PROPER AIR CIRCULATION NEXT In order to ensure proper temperatures, air must flow 1. Clean your refrigerator thoroughly and wipe off dust between the refrigerator and freezer sections. As shown accumulated during shipping. 2. Install accessories such as ice cube bin, drawers, in the illustration below, cool air enters through the refrigerator of the freezer section and moves up.
ICEPLUS Press thisbutton onceto activate theiceplusfunction. Dispenser selection indicator TheICEPLUSicononthedisplay panel w ill illuminate Shows cubed ice or crushed whenactivated. Theiceplusfunction runsthefreezer ice selection that will be compartment atthecoldest s ettings fora 24hourperiod to increase icemaking by uptoabout20%,andthen dispensed when the push turnoffautomatically.
FOOD STORAGE GUIDE ADJUSTING CONTROL SETTINGS Give the refrigerator time to cool down completely Wrap or store food in the refrigerator in airtight and moisture-proof material unless otherwise noted. This before making final adjustments. It is best to wait 24 hours before doing this.
STORING FROZEN FOOD WATER DISPENSER NOTE: For further information about preparing food for • Tray can be easily removed by pressing and pulling it. freezing or food storage times, check a freezer guide or a reliable cookbook. Packaging Successful freezing depends on correct packaging. When you close and seal the package, it must not allow air or moisture in or out.
WATER FILTER Before removing or installing water filter: 1. Take out the top shelf and move it to the lowest level. 2. Remove the lamp cover by pressing the tab under the cover and pulling cover to the front. 3. IMPORTANT: Turn off household water supply. Installing the water filter Remove red cap from the filter and insert the two...
DOOR LINERS AND GASKETS Do not use cleaning waxes, concentrated detergent, bleaches, or cleaners containing petroleum on plastic refrigerator parts. Use a clean sponge or soft cloth and a mild detergent in warm water. Wash, rinse and dry all surfaces thoroughly. PLASTIC PARTS (covers and panels)
6.Take outallremovable p arts, w rapthemwelland The icemaker will fill with water when it cools to freezing. tapetogether s otheydon'tshiftandrattle duringthe A newly-installed refrigerator may take 12 to 24 hours to move. R efertosections inUsing yourRefrigerator for begin making ice cubes. removal instructions.
BEFORE YOU BEGIN Two 1/4" outer diameter compression nuts and 2 This water line installation is not warranted by the Ferrules (sleeves) refrigerator or icemaker manufacturer. Follow these connect the copper tubing to instructions carefully to minimize the risk of expensive the shutoff valve and the water damage.
Page 21
ROUTE THE TUBING 3. DRILL THE HOLE FOR THE VALVE Route the tubing between the cold water line and the Drill a 1/4" hole in the water refrigerator. pipe (even if using a self- piercing valve) using a Route the tubing through a hole drilled in the wall or sharp bit.
Page 22
9. CONNECT THE TUBING TO THE 10. TURN THE WATER ON AT THE REFRIGERATOR SHUTOFF VALVE Tighten any connections that NOTES: leak. • Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged Reattach the compressor in to the wall outlet.
Page 23
The defrost timer will click when the automatic defrost UNDERSTANDING SOUNDS YOU MAY cycle begins and ends. The thermostat control (or HEAR refrigerator control, depending on the model) will also Your new refrigerator may make sounds that your old click when cycling on and off. one didn't make.
LAMPS DO NOT WORK Check if... Then... Light bulb has burned out. Replace with an appliance bulb of the same wattage, size and shape available at your local hardware store. (See the LAMP REPLACEMENT Section.) Turn the temperature control to the OFF position and unplug the refrigerator prior to replacement.
Page 25
THE ICEMAKER IS NOT PRODUCING ICE OR ICE CUBES ARE FREEZING TOO SLOWLY Check if... Then... The freezer temperature is cold enough to produce ice, SETTING THE CONTROLS section, t Wait 24 hours after hook-up for ice production. See the Door left open, Check to see if something is holding the door open,...
Page 26
TEMPERATURE IS TOO WARM OR THERE IS INTERIOR MOISTURE BUILDUP (CONTINUED) Check if... Then... The doors are opened often. When the door is opened, warm humid air is allowed into the refrigerator. The more the door is opened, the faster the humidity builds up, and the more warm air the refrigerator must cool.
Page 27
HAS OFF-TASTE OR ODOR Check if... Then... Discard first few batches of ice to avoid discolored or The icemaker was recently installed, off-flavored ice. The ice has been stored for too long. Throw away old ice and make new supply. The food has not been wrapped tightly in Rewrap foods since odors may migrate to the ice if food either compartment,...
Damages caused during and/or after delivery Display, discount, or refurbished units purchased with scratches, dents, or defects. Proof of purchase is required and must be provided to LG in order to validate warranty. Therefore, these costs are paid by the consumer.
Page 29
LG Electronics Inc. http://www.lge.com P/N: MFL62306001...
Need help?
Do you have a question about the LSC27921 Series and is the answer not in the manual?
Questions and answers