Table of Contents
Advertisement
AUTO PC adjust
Select [PC adjust] from the Main Menu (see
"Navigating through the menu" on page 40),
then select the item from the sub-menu.
Remote Control
AUTO PC adj.
Auto PC adjustment function is provided to
automatically adjust [Fine sync], [Total dots],
[Horizontal] and [Vertical] positions to conform to your
computer.
Press ▲▼ to select [AUTO PC adj.] and
then press the <SELECT> button.
[Please wait...]
appears while the Auto PC
z
adjustment is in process.
To store adjustment parameters
The adjusted parameters from the Auto PC adjustment
can be stored in the projector. Once the parameters
are stored, the setting can be done just by selecting a
Mode (1–10) in the PC System Menu (see page 43).
See also [Store] on page 47.
Attention
[Fine sync], [Total dots], [Horizontal] and [Vertical]
z
position of some computers cannot be fully adjusted
with the Auto PC adjustment function. When the
image is not provided properly with this operation,
manual adjustments are required (
The Auto PC adjustment cannot be operated when
z
[480i], [576i], [480p], [576p], [720p], [1035i] or [1080i]
is selected in the PC System Menu (
when the signal is coming from the HDMI terminal.
Control Panel
Æ
pages 46-47).
Æ
page 44), or
AUTO PC adjust
ENGLISH -
45
Advertisement
Table of Contents
