Table of Contents
Advertisement
4
Screen Adjustment
4.3
PIP/PBP
The PIP (Picture in Picture) function separates the screen into two parts. One source device is displayed
on the main screen at the same time the another source device is displayed in inset windows.
The PBP (Picture by Picture) function separates the screen in half displaying output from two different
source devices simultaneously on the left and right sides of the screen.
Compatible with Windows7 and Windows8.
The
used. If the screen is blank in
Control Panel
(Instructions are based on Windows 7.) If the screen is blank when the resolution is set to the
optimum resolution, change the resolution to 1280 x 1024.
The screen may flicker briefly or appear after a delay when you enable or disable the
function or when you change the screen size with the
This can typically arise when a PC and a monitor are connected to two or more input sources. It
has nothing to do with the performance of a monitor.
The issue is mainly caused when the video signals are delayed in transmission to the monitor
depending on the graphics card performance.
To maximize the picture quality, it is recommended to use a graphics card that supports
2K (2560 x 1440) resolution.
When the
optimum resolution due to a compatibility issue between the graphics card and the Windows
operating system. Set
resolution using the Windows interface.
PIP/PBP
function may not be available depending on the specifications of the graphics card
PIP/PBP
→
Display
→
PIP/PBP
function is enabled, the resolution may not automatically switch to the
PIP/PBP Mode
mode when the optimum resolution is selected, go to
Screen Resolution and click Detect on the PC.
PIP/PBP
to
Off
or manually change the resolution to the optimum
PIP/PBP
function activated.
4 Screen Adjustment
56
Advertisement
Table of Contents
