Table of Contents
Advertisement
Menu navigation
Menu navigation
The on-screen menu (Menu) is used to perform various settings and adjustments of the projector.
Navigating through the menu
■ Operating procedure
▶
button
1) Press the <MENU> button on the
remote control or the control panel.
▶
z The [MAIN MENU] screen is displayed.
2) Press ▲▼ to select the main menu
item.
▶
z The selected item is highlighted in yellow.
3) Press the <ENTER> button.
▶
z The sub-menu items of the selected main menu
are displayed.
4) Press ▲▼ to select a sub-menu, and
press ◀▶ or the <ENTER> button to
change or adjust settings.
44 - ENGLISH
z For some items, press ◀▶ to display an
▶
individual adjustment screen with a bar scale as
shown in the following diagram.
Note
z Pressing the <MENU> button when the menu
screen is displayed returns to the previous menu.
z Some items may not be adjusted or used for
certain signal formats to be input to the projector.
The menu items that cannot be adjusted or used
are shown in gray characters, and they cannot be
selected.
z Some items can be adjusted even if signals are not
input.
z Individual adjustment screen is cleared
automatically if no operation is performed for
approximately five seconds.
z For menu items, see "Main menu" (
"Sub-menu" (
pages 45 to 46).
z The cursor color depends on the [OSD DESIGN]
(
page 62) settings on the menu. The selected item
is displayed with the yellow cursor by default.
■ Resetting to the factory default
▶
If the <DEFAULT> button on the remote control is
pressed, the values adjusted in the menu items
will be restored to the factory default settings.
button
Press the <DEFAULT> button on the
remote control.
page 45) and
Advertisement
Chapters
Table of Contents
