Table of Contents
Advertisement
[COOLING CONDITION]
Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] correctly in accordance with the direction of projection referencing the following figure. Using the light source with
incorrect settings may shorten its life.
[VERTICAL UP SETTING]
30°
[FLOOR
30°
SETTING]
[VERTICAL DOWN SETTING]
：
Projection direction
1)
Press as to select [COOLING CONDITION].
2)
Press the <ENTER> button.
f The [COOLING CONDITION] screen is displayed.
3)
Press as to select a cooling condition.
4)
Press the <ENTER> button.
5)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[ECO MANAGEMENT]
A function that optimizes the light source power to suit usage conditions to reduce power consumption.
Setting [LIGHT POWER]
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [LIGHT POWER].
4)
Press qw to switch [LIGHT POWER].
f The items will switch each time you press the button.
[NORMAL]
[ECO SAVE1]
[ECO SAVE2]
[LOW]
Note
f The rate of power consumption reduction when the eco save mode is set refers to the ratio of average power consumption when a
"Broadcast" video signal that complies with IEC62087 is projected.
f When [ECO SAVE1] and [ECO SAVE2] is set, the image may appear differently to [NORMAL].
f If you feel that the brightness has decreased with [ECO SAVE2], switching to [ECO SAVE1] may improve the image.
f When [LOW] is set, the operating noise can be reduced.
f When the VIDEO input is selected, [ECO SAVE1] and [ECO SAVE2] cannot be selected. When [ECO SAVE1] or [ECO SAVE2] is set while
selecting other than VIDEO input, and when the VIDEO input is selected, [LOW] is set.
f When [NATURAL] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may not
conform to sRGB standards.
f When [REC709] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may not
conform to Rec.709 standards.
f When [DICOM SIM.] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may
appear different from the image of DICOM standards.
f Cannot be selected when viewing 3D videos. This is fixed to [NORMAL].
Chapter 4 Settings — [PROJECTOR SETUP] menu
30°
[CEILING
[FLOOR SETTING]
30°
SETTING]
Sets when high luminance is required.
Reduces the power by approximately 20 % in average compared to [NORMAL] without affecting the
brightness.
Reduces the power by approximately 30 % in average compared to [NORMAL], minimizing reduction
in brightness.
Sets this when you want to save more power without the need for high brightness.
15°
15°
15°
15°
[PORTRAIT SETTING]
Frontward: Projection direction
ENGLISH - 77
[CEILING SETTING]
Advertisement
Table of Contents
