Table of Contents
Advertisement
Connection is not possible.
The BLUETOOTH device you
• •
attempted to connect does not
support the A2DP profile, and
cannot be connected with the
system.
Enable the BLUETOOTH function of
• •
the BLUETOOTH device.
Establish a connection from the
• •
BLUETOOTH device.
The pairing registration
• •
information has been erased.
Perform the pairing operation
again.
Erase the pairing registration
• •
information of the BLUETOOTH
device (page 26) and perform
the pairing operation again (page
25).
The sound skips or fluctuates, or
the connection is lost.
The system and the BLUETOOTH
• •
device are too far apart.
If there are obstacles between
• •
the system and your BLUETOOTH
device, remove or avoid the
obstacles.
If there is equipment that
• •
generates electromagnetic
radiation, such as a wireless LAN,
other BLUETOOTH device, or a
microwave oven nearby, move
them away.
The sound of your BLUETOOTH
device cannot be heard on this
system.
Increase the volume on your
• •
BLUETOOTH device first, then
adjust the volume using VOL +/–.
There is severe hum, noise, or
distorted sound.
If there are obstacles between
• •
the system and your BLUETOOTH
device, remove or avoid the
obstacles.
44
US
If there is equipment that
• •
generates electromagnetic
radiation, such as a wireless LAN,
other BLUETOOTH device, or a
microwave oven nearby, move
them away.
Turn down the volume of the
• •
connected BLUETOOTH device.
Party Chain
Party Chain function cannot be
activated.
Check the connections
• •
(page 33).
Make sure the audio cables are
• •
connected correctly.
"PARTY CHAIN" is flashing on the
display.
You cannot select AUDIO IN
• •
function if you make connection
(page 33) during Party Chain
function. Select other function
(page 35).
Touch PARTY CHAIN on the unit.
• •
Restart the system.
• •
Party Chain function does not
work properly.
Turn off the system. Then, turn it
• •
back on again to activate the Party
Chain function.
Resetting the system
If the system still does not operate
properly, reset the system to factory
default settings.
Use the keys on the touch panel of
the unit to perform this operation.
1
Unplug the AC power cord (mains
lead), then plug it back in.
2
Press to turn on the system.
Advertisement
Table of Contents
