Table of Contents
Advertisement
en Troubleshooting
Fault
Loud noises during the spin
cycle.
Banging noises, rattling in
the drain pump.
Slurping, rhythmical suction
noise.
Problem with results
Fault
Creasing.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
56
Cause
Transit bolts have not been
removed.
Foreign bodies have got into
the drain pump.
The drain pump is active, the
detergent solution is
pumped out.
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
A low spin speed is selected.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Unsuitable detergent added
to the dispenser of the intelli-
gent dosing system.
troubleshooting
Removing the transit bolts
▶
→ "Cleaning the drain pump",
▶
Page 45
Not a fault – normal operating
▶
noise.
troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 26
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the programme.
▶
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the programme.
▶
Start the
programme.
▶
Check whether the detergent used
1.
is suitable.
→ "Detergents and care products",
Page 35
Drain the dispenser.
2.
→ "Cleaning the detergent drawer",
Page 43
Clean the dispenser.
3.
Advertisement
Table of Contents
