Table of Contents
Advertisement
Configuring the LAN Control Settings
If you are in a DHCP environment:
1.
Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
2.
Open the OSD menu and go to the ADVANCED > LAN Control Settings menu.
3.
Press Enter. The LAN Settings page is displayed.
4.
Highlight LAN Settings and press
5.
Press
to highlight Apply and press Enter.
6.
Please wait for around 15 - 20 seconds, and then re-enter the LAN Settings page. The
Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings
will be displayed. Note down the IP address displayed in the Projector IP Address
row.
If the Projector IP Address still does not appear, contact your network administrator.
If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default
Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
If you need to connect to the projector in its standby mode, set Standby LAN Control to On in
the ADVANCED > LAN Control Settings menu.
If you are in a non-DHCP environment:
1.
Repeat steps 1-3 above.
2.
Highlight LAN Settings and press
3.
Contact your ITS administrator for information on the Projector IP Address, Subnet
Mask, Default Gateway, and DNS Server settings.
4.
Press
to select the item you want to modify and press Enter.
5.
Press
/
to move the cursor and the press
6.
To save the settings, press Enter. If you do not want to save the settings, press Exit.
7.
Press
to highlight Apply and press Enter.
If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default
Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
If you wish to connect to the projector in its standby mode, be sure you have selected Static IP
and obtained the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server
information when the projector is on.
Controlling the projector through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
If you are using Microsoft Internet Explorer, make sure it is version 7.0 or higher.
The screen shots in this manual are for reference only, and may differ from the actual design.
1.
Enter the address of the projector in the address bar of your browser and press Enter.
/
to select DHCP ON.
/
to select Static IP.
/
to enter the value.
33
Advertisement
Table of Contents
