Parameter
Set Supervisor
Password
Set User
Password
Password On
Boot
TPM Support
(optional)
Setting a system password
1
Use the up/down keys to select a password parameter (Set Supervisor
Password or Set User Password), then press <Enter>.
A password box will appear.
2
Type a password then press <Enter>.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3
Retype the password to verify the first entry then press <Enter> again.
4
Press <F10>.
5
Select Yes to save the new password and close the Setup Utility.
Changing a system password
1
Use the up/down keys to select a password parameter (Set Supervisor
Password or Set User Password), then press <Enter>.
2
Type the original password then press <Enter>.
3
Type a new password then press <Enter>.
4
Retype the password to verify the first entry then press <Enter> again.
5
Press <F10>.
6
Select Yes to save the modified password and close the Setup Utility.
Description
Press <Enter> to configure the supervisor
password.
Press <Enter> to configure the user
password.
Select Enabled to activate security check
during POST.
Enables or Disables TPM support.
57
Options
Disabled
Enabled
Disabled
Enabled