Table of Contents
Advertisement
USING THE PROJECTOR
Setup menu
otee:
Functions vary depending on model definition.
Setup projection menu
Projection
Select the preferred projection between front, rear, ceiling-top, and rear-top.
Setup screen type menu
Screen Type (for WXGA/WUXGA model only)
Choose the screen type from 16:9 and 16:10.
Setup power settings menu
Direct Power On
Choose "On" to activate Direct Power mode. The projector will automatically power on when AC power is supplied,
without pressing the "Power" key on the projector keypad or on the remote control.
Signal Power On
Choose "On" to activate Signal Power mode. The projector will automatically power on when a signal is detected,
without pressing the "Power" key on the projector Keypad or on the remote control.
otee:
Only supported on HDMI 1, HDMI 2 and VGA In Connector.
Auto Power Off (min.)
Sets the countdown timer interval. The countdown timer will start, when there is no signal being sent to the
projector. The projector will automatically power off when the countdown has finished (in minutes).
Power Mode (Standby)
Set the power mode setting.
Active: Choose "Active" to return to normal standby.
‡
‡
Ecoe: Choose "Eco." to save power dissipation further < 0.5W.
USB Power (Standby)
Enable or disable the USB power function when the projector is in standby mode.
Setup security menu
Security
Enable this function to prompt for a password before using the projector.
‡
One: Choose "On" to use security verification when the turning on the projector.
‡
Off: Choose "Off" to be able to switch on the projector without password verification.
Security Timer
Can be select the time (Month/Day/Hour) function to set the number of hours the projector can be used. Once this
time has elapsed you will be requested to enter your password again.
Change Password
Use to set or modify the password that is prompted when turning the projector on.
otee:
Password default value is "1234" (first time).
41
English
Advertisement
Table of Contents
